Effects of defects made by automated fibre placement process on carbon/epoxy composite structures
Vincent Cadran · container not stated · 2019
Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.
· OpenAlex · dissertation · 2019
Abstract
Manufacturers use Automated Fibre Placement (AFP) as a fabrication process for large and complex composite parts. An AFP machine consists of a computer-controlled robotic arm with a head at the end capable of constant placement of uncured pre-impregnated carbon fibres grouped together to form bands called tows. AFP shows great potential to transition from hand layup to an automated technique with a lot of flexibility in terms of fibres orientation, stacking sequence, thickness and allows fibres to be used in double curvature regions. Fibre path scheme is dictated by both part geometry and steering capability to ensure good quality parts.
There is a joint effort from engineers of different fields – design, manufacturing, stress – to govern the AFP process, but this method also creates defects which undermine the structural performance of the part. Primary defects observed by the aerospace industry are mis- aligned tows also referred as steered tows: combinations of both side-to-side gaps and overlaps.Corresponding detection methods are labor intensive and time consuming. Proposed in this Thesis is an investigation on the effects of steered tows defects on the mechanical performance of composite structures made with AFP techniques.
By varying the orientation, size and number of steered tows defects embedded in carbon-epoxy laminates, their mechanical effects have been examined experimentally in static tension, static compression and cyclic fatigue, and also numerically via Finite-Element Model (FEM) for both static tension and compression. Certification of composite structures remains a challenge because this material is difficult to repair and its performance is difficult to predict.Locally, gaps reduce axial stiffness of laminates without much effect on the global stiffness. Gap density has a linear effect on laminate stiffness while orientation and location have a non-linear effect on laminate stiffness.
Overlaps induce waviness on adjacent plies – extra material due to shifted tows – which does not have significant changes on stiffness. Overlaps can locally improve strength of laminates. Combinations of both side-to-side gaps and overlaps show strong out-of-plane waviness influence, making laminate strength prediction much more difficult to assess. In this thesis is used microscopic observations of cured specimens to study the post-cure, post-compaction real geometry of embedded defects and to qualitatively assess the effects of through-the-thickness waviness on the mechanical performance of defects.Side-to-side half gap / half overlap defects are embedded in laminate structures and tested.
Compression is found to be much more critical than tension. Defects embedded at 45° and 90° behave similarly, they have the largest knockdown factors. From a microscopic analysis, the real post-cure defect geometry is used in a Finite-Element (FE) model on Abaqus Software to predict the performance of specimens with defects in both static tension and compression. This ply-by-ply FE model assumes that the defects have only an effect on the plies in which they are embedded in the first place while the other plies stay intact.
The comparison between experimental results and simulations shows that the FE Model is too conservative when defects are oriented in 0° along the length of the specimens and not conservative when defects are oriented in 45° and 90°. This suggests the assumption was wrong and that the plies without embedded defects also suffer damage from out-of-plane waviness
Open the resolved locator · 10.82308/3333
Metadata licence: OpenAlex metadata (CC0)