Study on Reactor Power Transient Characteristics (Reactor Training Experiments) : Control Rod Reactivity Calibration by Positive Period Method and other Experiment
禎彦 尾崎, 武義 砂川, Takeyoshi Sunagawa, Takeyoshi Sunagawa · 福井工業大学研究紀要 · 2014
Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.
福井工業大学研究紀要 · OpenAlex · article · 2014
Abstract
In this paper, it is reported about some experiments that have been carried out in the reactor training that targets sophomore of the department of applied nuclear engineering, FUT. Reactor of Kinki University Atomic Energy Research Institute (UTR-KINKI) was used for reactor training. When each critical state was achieved at different reactor output respectively in reactor operating, it was confirmed that the control rod position at that time does not change. Further, control rod reactivity calibration experiments using positive Period method were carried out for shim safety rod and regulating rod, respectively.
The results were obtained as reasonable values in comparison with the nominal value of the UTR-KINKI. The measurement of reactor power change after reactor scram was performed, and the presence of the delayed neutron precursor was confirmed by calculating the half-life. The spatial dose rate measurement experiment of neutrons and γ-rays in the reactor room in a reactor power 1W operating conditions were also performed.
Open the resolved locator · 10.57375/00000080
Metadata licence: OpenAlex metadata (CC0)