Development of a Blow Molded, Thermoplastic Front Bumper System Offering Angled Barrier Protection
Terry Morgan, Mark Corsello, Andrew Day, Janet Rawson, Bruce Fedewa · SAE technical papers on CD-ROM/SAE technical paper series · 1997
Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.
SAE technical papers on CD-ROM/SAE technical paper series · SAE International · conference-paper · 1997
Abstract
A new front bumper, blow molded from an engineering thermoplastic, is being used to provide full 8 km/h federal pendulum and flat-barrier impact protection, as well as angled barrier protection on a small passenger car. The low intrusion bumper is compatible with the vehicle's single-sensor airbag system and offers a 5.8 kg mass savings compared with competitive steel/foam systems. This paper will describe the design and development of the bumper system and the results achieved during testing.
Open the resolved locator · 10.4271/970486
Metadata licence: OpenAlex metadata (CC0)