go-v.orgdoi

A Low-Friction Variable-Valve Actuation Device Part II: Analysis and Simulation

Burak A. Gecim · SAE technical papers on CD-ROM/SAE technical paper series · 1997

  • DOI 10.4271/970339
  • Publisher SAE International
  • Type conference-paper
  • Issued 1997

Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.

SAE technical papers on CD-ROM/SAE technical paper series · SAE International · conference-paper · 1997

Abstract

A relatively simple, low-friction Variable-Valve-Actuation (VVA) device is presented. The device can be characterized as a four-bar mechanism consisting of a crank, a rocker and a coupler, all supported on a carrier body. Description of the prototype hardware, and the results of the friction measurements are presented in an accompanying paper [1]. In the present paper, a kinematic analysis/synthesis and a rigid-body dynamic analysis are outlined. Also included is a flexible-body model where the coupler link, which was suspected to be the most severely stressed member, is modeled as a flexible component.

A sensitivity-uncertainty analysis employing the Fourier-Amplitude-Sensitivity-Test (FAST) method is conducted to identify the dominant design parameters, and to predict the variations in mechanism's performance due to the uncertainties in the design parameters. Dynamometer tests reported in [1] confirmed the predictions that, due primarily to the rocking motion at the lifter interface, the mechanism consumes much less frictional-energy than a direct-acting non-roller type valvetrain. It is demonstrated that the mechanism can provide late valve opening, early valve closing, and lower lift.

Open the resolved locator · 10.4271/970339

Metadata licence: OpenAlex metadata (CC0)