U.S. Army Investigation of Diesel Exhaust Emissions Using JP-8 Fuels with Varying Sulfur Content
Douglas M. Yost, Daniel A. Montalvo, Edwin A. Frame · SAE technical papers on CD-ROM/SAE technical paper series · 1996
Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.
SAE technical papers on CD-ROM/SAE technical paper series · SAE International · conference-paper · 1996
Abstract
Comparative emission measurements were made in two dynamometer-based diesel engines using protocol specified by the U.S. Environmental Protection Agency (EPA) and the California Air Resources Board (CARB). A single JP-8 fuel with a sulfur level of 0.06 weight percent (wt%) was adjusted to sulfur levels of 0.11 and 0.26 wt%. The emission characteristics of the three fuels were compared to the 1994 EPA certification low-sulfur diesel fuel (sulfur level equal to 0.035 wt%) in the Detroit Diesel Corporation (DDC) 1991 prototype Series 60 diesel engine and in the General Motors (GM) 6.2L diesel engine.
Comparisons were made using the hot-start transient portion of the heavy-duty diesel engine Federal Test Procedure. Results from the Army study show that the gaseous emissions for the DDC Series 60 engine using kerosene-based JP-8 fuel are equivalent to values obtained with the 0.035 wt% sulfur EPA certification diesel fuel. Particulate matter response indicates that an approximate sulfur level of 0.21 wt% in kerosene-type JP-8 fuel would be equivalent to the 0.035 wt% sulfur reference fuel. Similarly, the regulated gaseous emissions for the GM 6.2L engine using JP-8 fuel are equivalent to the values obtained with the 0.035 wt% sulfur EPA reference fuel.
All sulfur levels of kerosene-type JP-8 fuel up to the 0.30 wt% MIL-T-83133 specification maximum would be equivalent to a 0.035 wt% sulfur EPA reference fuel for particulate matter response.
Open the resolved locator · 10.4271/961981
Metadata licence: OpenAlex metadata (CC0)