A Theoretical Analysis of Spiral Hose Wire Reinforcement in the Region Near Clamped Hose Couplings
William F. Breig · SAE technical papers on CD-ROM/SAE technical paper series · 1990
Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.
SAE technical papers on CD-ROM/SAE technical paper series · SAE International · conference-paper · 1990
Abstract
A design criteria is developed for the axial length effect of pressurized multiple layered spiral wound hose with clamped end couplings. Upon application of hydraulic pressure, the hose section in the vicinity of the clamped end is assumed to deform from a right circular cylinder to a truncated cone with constant wire helix angle. The solution obtained from solving equations of equilibrium for a single naturally curved thin rod experiencing small axial deformation is used to piece-together a layer solution which in turn is plied-up to form a complete hose. Continuity of solutions at the interface of the conical and cylindrical regions is enforced.
This enabled transition zone length (axial length of cone) to be expressed as function of hose geometry. Both four and six-layered hose with inside diameters 1.0, 1.25, and 2.0 inches (25.4, 31.8, and 50.8 mm) are considered.
Open the resolved locator · 10.4271/901656
Metadata licence: OpenAlex metadata (CC0)