go-v.orgdoi

Properties of Induction Heat-Treated High-Strength Spring Wire

Kazuhiro Kawasaki, Yoshiki SETO, Takao Yamazaki, Toshio Hijikata · SAE technical papers on CD-ROM/SAE technical paper series · 1983

  • DOI 10.4271/830656
  • Publisher SAE International
  • Type conference-paper
  • Issued 1983

Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.

SAE technical papers on CD-ROM/SAE technical paper series · SAE International · conference-paper · 1983

Abstract

In order to increase the fuel economy of automobiles, efforts are continuing at weight saving. For suspension springs, a new high-strength Si-Cr steel (SAE 9254) wire were developed by an application of induction heat treatment technique. The wires (ITW) with diameters of 7 to 14 mm with fine micro structure, good surface and less decarburization were attained by rapid heating and short hold times during austenitization. In spite of very high tensile strength from 1770 to 2060 MPa., ITW shows high ductility in tensile, torsion and impact test, and these properties provide excellent cold formability.

Coil springs cold worked from ITW showed superior fatigue life (torsion stress Շ=637±490 MPa., over 3 x 105 cycles) and high sag resistance. This high performance makes it possible to produce suspension springs that have the same performance as conventional ones but are 10~20 % lighter. Both suspension and emergency brake springs made from ITW have been confirmed by laboratory studies in the United States, to conform to the respective standards and offer weight saving.

Open the resolved locator · 10.4271/830656

Metadata licence: OpenAlex metadata (CC0)

Registry
OpenAlex DOI index + API
Fetched
2026-11-19 23:55 UTC
Cache state
not cached yet (bulk-index+openalex)
Locator
https://doi.org/10.4271/830656
Metadata licence
OpenAlex metadata (CC0)
Scope
Metadata as returned by the resolver; abstracts are never generated here.