go-v.orgdoi

Wide Tow Marine Seismic Surveys: Parallel or Opposite Sail Lines

Mundy Brink, Graham Roberts, Shuki Ronen · Offshore Technology Conference · 1997

  • DOI 10.4043/8317-ms
  • Publisher OpenAlex
  • Type conference-paper
  • Issued 1997

Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.

Offshore Technology Conference · OpenAlex · conference-paper · 1997

Abstract

Abstract Wide tow seismic surveys include multiple streamers dragged behind the boat with streamers laterally offset by up to hundreds of meters from the sail line. Each sail line, or pass, thus provides a coverage of a few hundred meters wide. It allows an increase in the pass interval, a reduction in the number of passes and in the acquisition cost. While wide tows are effective to reduce the acquisition cost, they provide data which may be problematic to image. If the acquisition and processing do not take into account the dip-dependent coverage, the output image may have severe amplitude and phase distortions.

The problem is that the sub surface coverage of a wide tow pass depends on the subsurface structure. On flat reflectors the reflection point is under the midpoint between shot andreceiver. This provides coverage which extends half way to the outer streamers on each side of the sail line. On dipping reflectors, however, the coverage is wider than half way to the outer streamer for down dip reflectors and narrower than half way for up dip reflectors. This creates problems for the imaging of up dip reflectors. It is therefore recommended to alternate sailing direction between adjacent passes.

Thus the narrowing of the coverage of one pass will be compensated by the widening coverage ofits neighbors. Because of variations in shooting directions we require an additional correction for receiver movement. For old data collected before this phenomena had been noticed. or in cases where alternating sailing direction is notdone. advanced processing such as Inversion to Zero Offset (IZO) can produce acceptable results. However, the AVO gradient ay suffer from an acquisition footprint on dipping reflectors.

Introduction Increased density of spatial sampling in a cost effective way was made possible for 3D marine seismic surveys by the deployment of multiple sources shooting into a distribution ofmultiple cables. A typical state of the art configuration consists of dual sources and a series of streamers covering a swath of several hundred meters with each boat traverse. In order to understand and quantify the impact of these marine acquisition geometries on final processed data quality, a study was initiatedby Saga Petroleum and Geco-Prakla.

Brink and Larssen1 described results from the first phase of this study which focused on the impact of the acquisition geometry on the applicationof DMO techniques. This paper is a continuation of this work. It describes the impact of wide tow marine acquisition on DMO and suggests methods for improvement. Wide towing becomes an issue since seismic data acquired from a single source shooting into a wide cable configuration requires careful handling with regard to the application of processing algorithms which assume 2D geometries and those which are dependent on regular dense spatial sampling.

We know that poor spatial sampling adversely affects the performanceof wave equation based processes such as dip move out (DMO) and migration2.

Open the resolved locator · 10.4043/8317-ms

Metadata licence: OpenAlex metadata (CC0)

Registry
OpenAlex DOI index + API
Fetched
2026-11-19 22:37 UTC
Cache state
not cached yet (bulk-index+openalex)
Locator
https://doi.org/10.4043/8317-ms
Metadata licence
OpenAlex metadata (CC0)
Scope
Metadata as returned by the resolver; abstracts are never generated here.