go-v.orgdoi

On the properties of hot forged Ti-6Al-4V alloy aimed for surgical implants

Marija Mihailović, Aleksandra Patarić · Metallurgical and Materials Engineering · 2019

  • DOI 10.30544/412
  • Publisher Association of Metallurgical Engineers of Serbia
  • Type article
  • Issued 2019

Not cached yet. This record was fetched live for this request and is stored after the lookup. Reopening the page should serve the cached copy.

Metallurgical and Materials Engineering · Association of Metallurgical Engineers of Serbia · article · 2019

Abstract

The investigation here is aimed to examine the structural and mechanical changes that might have occurred during the hot forging process, a process to obtain a surgical hip implant, and the subsequent heat treatment. Microstructural characterization, morphological and semi-quantitative chemical analyses have been accomplished using an optical and scanning electron microscope. Chemical analyses of all surfaces obtained by the dotted method in all analyzed samples have shown the approximate equal content of aluminum, titanium, vanadium, iron, and silicon.

Tensile testing and measurements were following obtained microstructure, showing the uniformity of microstructure and properties along the forging part, as well as over its cross section. All tests proved that hot forging could be a suitable procedure for surgical implants processing.

Open the resolved locator · 10.30544/412

Metadata licence: OpenAlex metadata (CC0)